Reviews

Dave B

Cool product, fits perfectly and very fast shipping.

Jonathan

When I first put the plate on my Milwaukee M18 table saw, I was nervous because they didn't quite fit. But after literally 4-5 minutes of light sanding, not only did they fit, but they fit PERFECTLY. The original throat plate that comes with the saw is made a bit loose and there is a plastic locking mechanism to hold it in place. I was worried that without that, these new throat plates would not fit snugly. Boy - was I wrong about that! They fit so well that they go in with a tap and come out with a gentle tug and don't move at all. So there is absolutely no need for the locking mechanism. As for value, the Milwaukee zero clearance (plastic) plate is $60 on Amazon so not only are these ToolCurve products far better quality, but much less expensive as well. As well, Milwaukee doesn't even make dado throat plates. I'll be getting one ToolCurve dado plate for each of my common dada widths because it's such a great value. GREAT product. I am a very happy camper!

Jonathan

When I first put the plate on my Milwaukee M18 table saw, I was nervous because they didn't quite fit. But after literally 4-5 minutes of light sanding, not only did they fit, but they fit PERFECTLY. The original throat plate that comes with the saw is made a bit loose and there is a plastic locking mechanism to hold it in place. I was worried that without that, these new throat plates would not fit snugly. Boy - was I wrong about that! They fit so well that they go in with a tap and come out with a gentle tug and don't move at all. So there is absolutely no need for the locking mechanism. As for value, the Milwaukee zero clearance (plastic) plate is $60 on Amazon so not only are these ToolCurve products far better quality, but much less expensive as well. As well, Milwaukee doesn't even make dado throat plates. I'll be getting one ToolCurve dado plate for each of my common dada widths because it's such a great value. GREAT product. I am a very happy camper!

Kathleen

These are great and keep the clamps where I need them. I put some neon paint on mine in order to keep track of them. They not only fit my Bessey and Festool clamps, but also my Matchfit clamps. I\'m guessing some other similar clamps I have too (no-name brands).

Martin R.

Well designed fit. Used for slab mill and captured large amount of dust.

Martin R.

Works great. Used on the router to slab mill an endgrain. Greatly reduced dust.

Thomas Greisen

It is not tight enough on the shown dust collector.

Kathleen

Very happy to find a solution so the TSO square doesn\'t tip. Easy to install and works great. I had purchased a different square with a lip and stopped using the TSO square because it was unwieldy. The TSO square is larger and so more accurate than the smaller one with the lip, but now I can go back to using the TSO square. I haven\'t used the scale, but will see if it helps me in the future. Nice job, Toolcurve.

Steven Demeyer

The unit is nicely constructedand arrived on time. The placement of the pounting hole doesn't allow for the router to plunge all the way to the bottom of its intended travel. I moved the adapter back and drilled new holes which allow the plunge travel to come all the way down. I also added a piece of plexiglass on top of the base to increase the effectiveness of the adapter.

Steven Demeyer

The unit is nicely constructedand arrived on time. The placement of the pounting hole doesn't allow for the router to plunge all the way to the bottom of its intended travel. I moved the adapter back and drilled new holes which allow the plunge travel to come all the way down. I also added a piece of plexiglass on top of the base to increase the effectiveness of the adapter.