Customer Reviews

Every review, across every ToolCurve product — straight from the woodworkers who use them.

4.9 Based on 532 reviews
5 90% 4 9% 3 1% 2 0% 1 0%
Showing 26–30 of 506 reviews without photos Clear Filters
  1. Hop

    Each piece is about
    (19.9 mm) (.7435 in) (3/4 in) wide
    (9.6 mm) (.38 in) (3/8 in) high
    (224 mm) (8.82 in) (18 13/32 in) long

    Countersunk Holes are about 20 mm, 112 mm, 204 mm from the end

    Set of 4 Adjustable Miter Bars Table Saw Review of Set of 4 Adjustable Miter Bars Table Saw
    Helpful? (1) (0)
  2. Rockney Williams Verified Owner

    Port fit the saw and the Festool hose as advertised. Installation was easy, pop off the side plate, remove the factory port, seat the new port, put the side plate back on. The only improvement I could see would be for the port to rotate like the factory port does.

    Makita Track Saw No Snag Dust Port Review of Makita Track Saw No Snag Dust Port
    Helpful? (0) (2)
  3. Robert Abel Verified Owner

    I have not tried this yet but I like the fact that it will work for both the regular base and the plunge base

    Bosch 1617 Router Guide Rail Adapter Review of Bosch 1617 Router Guide Rail Adapter
    Helpful? (0) (1)
  4. Robert Abel Verified Owner

    They slide in fine; I have not used them yet.

    ToolCurve's Guide Rail Limit Stops Review of ToolCurve's Guide Rail Limit Stops
    Helpful? (0) (0)
  5. Robert Abel Verified Owner

    I tested it out and it worked well with my Kreg ACS track. I dropped it though, and it cracked. The price is too high.

    Dewalt Trim Router Guide Rail Adapter Review of Dewalt Trim Router Guide Rail Adapter
    Helpful? (1) (1)
Load More Reviews